Cold frames and hotbeds are miniature greenhouses that utilize the sun’s energy for heat. They are useful as season extenders, for propagating cuttings, for starting vegetable and flower transplants, etc. In the case of hotbeds, the sun’s energy is supplemented by heating cables or fresh manure. These structures have movable sashes or lids, which can be hinged to allow for easy opening and closing. The lid will allow access to the plants inside and be the source of ventilation and temperature control.
During the day the sun’s energy is transmitted through the lid and stored in the soil floor of the frame. At night, heat loss from the soil is slowed by the cold frame. Insulating the inside walls and covering the lid at night with old blankets can further reduce heat loss. A hotbed, in addition to slowing heat loss, would be able to replenish some of this lost heat due to its additional heat source.
A cold frame structure is simply placed over a cleared area of soil. Soil can be mounded against the base of the structure to prevent heat loss and wind from entering.
A hotbed, on the other hand, will be located over a bed of fresh manure and soil. Usually a hole slightly wider and longer than the dimensions of the frame is dug to a depth of approximately 3 feet. Fill the hole with 24-30 inches of fresh manure and top this with 6-12” of topsoil. The frame is then placed over this manure bed.
Plastic-covered waterproof heating cables are available from greenhouse suppliers and electric-supply houses. You may also be able to find suitable cables in gardening supply catalogs. These cables are flexible and easy to install and will function well for five years or more when used properly. It is very important to use cables intended for this purpose and to install the heating cables correctly. Read and follow all of the installation instructions.
If the hotbed is used for growing plants that are in containers or flats the cable can be placed in the middle of a 2-inch layer of sand. The sand is then covered with a wire mesh with holes no greater than 1 inch. The plant containers are placed on top of the wire mesh.
If you are actually planting seedlings directly into soil in the frame then the cable will need to be placed deeper in the soil. In this case dig out the topsoil to a depth of 8 inches and store the soil nearby. Level the bottom of the hole and lay the cable at the bottom making sure that none of the cable crosses itself. Cover the cable with 1- to 2-inches of sand and then place the same type of wire mesh mentioned above on top. Now backfill with the topsoil you stored and amend it if necessary (i.e. limestone, fertilizer, etc.) You are now ready to plant directly in this soil.
Resource: Greenhouses for Homeowners and Gardeners, NRAES-137, Natural Resource, Agriculture, and Engineering Service (NRAES), Ithaca, NY. 2000.
Revised 11/2003 by Thomas Kowalsick
Download a PDF of this tip.